Trunking and Grade of Service GOS 1 Trunking

Trunking and Grade of Service (GOS) 1

Trunking and Grade of Service (GOS) Trunking: n n A means for providing access to users on demand from available pool of channels. With trunking, a small number of channels can accommodate large number of random users. n n Telephone companies use trunking theory to determine number of circuits required. Trunking theory is about how a population can be handled by a limited number of servers. 2

Terminology: 1. Traffic intensity is measured in Erlangs: ¨ 2. 3. 4. One Erlang: traffic in a channel completely occupied. 0. 5 Erlang: channel occupied 30 minutes in an hour. Grade of Service (GOS): probability that a call is blocked (or delayed). Set-Up Time: time to allocate a channel. Blocked Call: Call that cannot be completed at time of request due to congestion. Also referred to as Lost Call. 5. 6. 7. Holding Time: (H) average duration of typical call. Load: Traffic intensity across the whole system. Request Rate: (λ) average number of call requests per unit time. 3

Traffic Measurement (Erlangs) 4

5

Tahir Iqbal, Air University 6

7

8

9

10

11

Erlang C Model –Blocked calls cleared n A different type of trunked system queues blocked calls –Blocked Calls Delayed. This is known as an Erlang C model. n Procedure: Determine Pr[delay> 0] = probability of a delay from the chart. ¨ Pr[delay � > t | delay �> 0 ] = probability that the delay is longer than t, given that there is a delay Pr[delay �> t | delay �> 0 ] =exp[-(C-A)t /H ] ¨ Unconditional Probability of delay �> t : Pr[delay �> t ] = Pr[delay �> 0] Pr[delay �> t | delay �> 0 ] ¨ Average delay time D = Pr[delay� > 0] H/ (C-A) ¨ 12

Erlang C Formula n The likelihood of a call not having immediate access to a channel is determined by Erlang C formula: 13

Tahir Iqbal, Air University 14

15

16

Improving Capacity in Cellular Systems n n Cost of a cellular network is proportional to the number of Base Stations. The income is proportional to the number of users. Ways to increase capacity: New spectrum –expensive. PCS bands were sold for $20 B. ¨ Architectural approaches: cell splitting, cell sectoring, reuse partitioning, microcell zones. ¨ Dynamic allocation of channels according to load in the cell (non-uniform distribution of channels). ¨ Improve access technologies. 3. 7 Improving Capacity in Cellular Systems ¨ 17

Cell Splitting n Cell Splitting is the process of subdividing the congested cell into smaller cells (microcells), Each with its own base station and a corresponding reduction in antenna height and transmitter power. n Cell Splitting increases the capacity since it increases the number of times the channels are reused. 18

An Example n n The area covered by a circle with radius R is four times the area covered by the circle with radius R/2 The number of cells is increased four times The number of clusters the number of channels and the capacity in the coverage area are increased Cell Splitting does not change the co-channel re-use ratio Q =D/R 19

Transmit Power n n n New cells are smaller, so the transmit power of the new cells must be reduced How to determine the transmit power? The transmit power of the new cells can be found by examining the received power at the new and old cell boundaries and setting them equal n Pr(at the old cell boundary) is proportional to n Pr(at the new cell boundary) is proportional to 20

Transmit Power 21

Application of cell splitting n n n Not all cells are split at the same time. Larger transmit power Some of the channels would not be sufficiently separated from the cochannel cells. Smaller transmit power --parts of the larger cells left uncovered Two groups: ¨ one that corresponds to the smaller cell and the other for larger cell reuse requirements 22

Application of cell splitting (cont. ) n n The sizes of these two groups depend on the stage of the splitting process At the beginning, fewer channels will be there in the smaller power group. As the demand grows, smaller groups would require more channels Cell splitting continues until all the channels are in the smaller power group Antenna Down tilting ¨ To limit the radio coverage of microcells 23

Cell Overlay n n It’s a relatively novel technique Cells used by A are divided into: ¨ Channels used by ‘a’ –those are used by ‘A’ only within radius R/2 from center. ¨ Channels not used by ‘a’ –no restrictions on their use in A. 24

Cell sectoring n Another way to reduce the number of cells in a cluster and hence, to reduce Interference is sectoring. Sectoring refers to the use of directional rather than omni antennas. Three (3) 120 degrees sectors are shown as an example n Analysis: mobile in center cell will experience interference from only 2 cells (not 6). Improvement of 6 d. B in S/I. Alternatively, try to reduce the reuse factor. Sectoring entails reduced trunking efficiency. 25

26

Tahir Iqbal, Air University 27

Example of Cell Sectoring n With omin directional antennas n Where we assumed that the power attenuation n = 4. For N = 4, we obtain S = 13. 8 d. B. For N = 4 and with 3 sectors, we get S = 19. 9 d. B: n 28

Microzones n n n Multiple zones and a base station make up a cell As a mobile travels within the cell, it is served by the zone with the strongest signal This technique is superior to sectoring because antennas are placed at the outer edges of the cell, and any base station channel can be assigned to any zone by the base station 29

Microzoning 30

ADVANTAGES n No handoffs is required at the MSC n The base station radiation is localized and interference is reduced. A given channel is active only in the particular zone in which the mobile is traveling n The co-channel interference is also reduced 31

n Decreased co-channel interference improves signal quality which leads to an increase in capacity without any degradation in trunking efficiency caused by sectoring n For example We know an (S/I) of 18 d. B is required for satisfactory system performance in narrowband FM 32

EXAMPLE n n n If a system with N=7 and (D/R)=4. 6, it can achieved a (S/I) of 18 d. B For a microcell zone system, since transmission at any instant is confined to a particular zone, this implies that a (Dz/Rz) of 4. 6 can achieve the required performance where, Dz = minimum distance between active co-channel zones and Rz = zone radius 33

34

EXAMPLE (cont. ) 35

36

Repeaters for Range Extension n Repeaters are radio re-transmitters used to provide coverage for hard-toreach areas, such as within buildings or in valleys or tunnels n Repeaters are bidirectional. Upon receiving signals from base station, then amplifies and reradiates the base station signals to the specific coverage region. Also it will send signals to the serving base station. n The repeaters do not add capacity to the system-it simply serves to reradiate the base station signal into specific locations 37

Repeaters for Range Extension 38

Summary for chapter 3 n Concepts of handoff, frequency reuse, trunking efficiency and frequency planning have been presented n The capacity of a cellular system depends on several factors and the methods to increase the capacity n The overriding objective of these methods is to increase the number of users in the system 39