Tray Tools Materials Processes The Pillar Drill can

Tray Tools, Materials & Processes

The Pillar Drill can be used to drill wood, metal, and plastic. As a general rule the larger the hole you are trying to drill the slower the drill should rotate. When using this (or any other machine) it is important to read the safety notice on the wall to make sure you understand how to use the machine safely. When using the Pillar Drill you must Wear Goggles Tie any long hair back Tuck in any loose clothing

The Pillar Drill On / Off Switch Depth Stop Drill Chuck Guard Machine Vice Chuck Key

Screwdriver Bit Cordless Drill Keyless Chuck Adjustable Clutch Forward / Reverse Switch On / Off switch The Cordless Drill can be fitted with a drill bit (1 mm to 10 mm) for drilling small holes, a Countersink bit for countersinking holes or a Screwdriver bit for driving in screws. Battery Pack

Drill Bits 1) Twist Drills 2) (Used for drilling wood, metal and plastic) 3) 2) Reduced Shank Twist Drill 4) (As above but reduced shank allows larger drill bits to be fitted in a chuck) 5) 3) Dowel bit 6) (Used to drill clean holes in wood for dowel joints) 7) 4) Spade Bit 8) wood) (Used for drilling large holes in 9) 5) Masonry Bit 10) (Used to drill holes in concrete) 11)6) Forstner Bit 12) (Used to drill clean flat bottomed holes in wood. Available in a wide range of sizes 6 – 50 mm)