The scroll saw can perform many types of

The scroll saw can perform many types of wood creations. Scroll Saw Capabilities

Intarsia � A decorative inlaid pattern in a surface, especially a mosaic worked in wood. Eagle Made from walnut, white birch, and yellow heart. � Forest Landscape Made from several types of material both stained and natural.

Marquetry � A decorative work in which elaborate patterns are formed by the insertion of pieces of material into a wood veneer that is then applied to a surface. Dolphin Veneers include mahogany, walnut, and maple. � Room Divider A large variety of veneers are used for this project.

Puzzles � Hippogryph Free standing puzzle with precise cuts and design. � Your Name You can create your own name that fits together.

Important information in regards to the parts of the scroll saw and how to properly use it. SCROLL SAW MACHINE

Scroll Saw Parts J K L R I H G P Q M F N E O D C B A

Questions 1 - 5 1. What is the scroll saw designed to do? Its meant to cut sharp curves on both outside and inside edges, as well as interior sections of a work piece. 2. The scroll saw moves in an up and down motion and cuts very similar to two types of saws. Which two? The coping saw and compass saw. 3. How is the size of a scroll saw determined? The distance between the blade and the over arm determines the size. 4. What are three types of blades available? Metal cutting, Spiral, and standard plain-end general purpose. 5. Which chuck controls the tension for the scroll saw? The upper chuck.

Questions 6 - 10 6. What part of the scroll saw is used to apply light pressure to the work piece? The hold down-foot 7. Name the six common cuts the scroll saw can make. Straight cuts, outside curves, inside curves, bevel curves, marquetry, and overlay cuts. 8. How many teeth per inch are required for cutting extremely thin wood? 20 teeth per inch 9. If the stock is cut too fast or turned to sharply what will happen to the blade? The blade will break. 10. A continuous line should not always mean a continuous cut. T/F That is true.

Questions 11 - 14 11. What is the first thing you should do before cutting internal curves? You should drill a relief hole. 12. An internal relief cut should always be cut on the waste stock of the material. T/F This statement is True. 13. At what degree should the table be set for cutting inlays? The table should be set at 1 or 2 degrees for inlay cuts.

Safety rules for your protection SCROLL SAW

Safety Rules (scroll saw) Protection from sawdust getting in your eye. Always wear eye protection. Be sure to install the blade in the vertical position with the teeth pointing down.

Safety Rules (scroll saw) üCheck the belt guard to see that it is closed and tight. üAdjust the hold down foot to the thickness of the stock being cut. üDo not allow your fingers to get any closer than two(2) inches from the blade when cutting. üKeep your fingers to the side of the blade, never in front. üCut round stock by holding it in a V-block fixture. üStop the scroll saw before you make any adjustments.