Solutions3 Colligative Properties Colligative Properties When a solute

  • Slides: 32
Download presentation
Solutions-3 Colligative Properties

Solutions-3 Colligative Properties

Colligative Properties • When a solute is added to a solvent, particles get in

Colligative Properties • When a solute is added to a solvent, particles get in the way of crystal formation. Freezing requires lower temperature.

Colligative Properties • When a nonvolatile substance is added to a solvent, it takes

Colligative Properties • When a nonvolatile substance is added to a solvent, it takes more energy to remove liquid molecules and change them to gas molecules. Boiling takes a higher temperature.

Colligative Properties • Changes in colligative properties depend only on the number of solute

Colligative Properties • Changes in colligative properties depend only on the number of solute particles present, not on the identity of the solute particles. • Among colligative properties are ØVapor pressure lowering ØBoiling point elevation ØMelting point depression ØOsmotic pressure

Vapor Pressure Because of solutesolvent intermolecular attraction, higher concentrations of nonvolatile solutes make it

Vapor Pressure Because of solutesolvent intermolecular attraction, higher concentrations of nonvolatile solutes make it harder for solvent to escape to the vapor phase.

Vapor Pressure Therefore, the vapor pressure of a solution is lower than that of

Vapor Pressure Therefore, the vapor pressure of a solution is lower than that of the pure solvent.

Raoult’s Law PA = XAP A where • XA is the mole fraction of

Raoult’s Law PA = XAP A where • XA is the mole fraction of compound A • P A is the normal vapor pressure of A at that temperature NOTE: This is one of those times when you want to make sure you have the vapor pressure of the solvent.

Boiling Point Elevation and Freezing Point Depression Nonvolatile solutesolvent interactions also cause solutions to

Boiling Point Elevation and Freezing Point Depression Nonvolatile solutesolvent interactions also cause solutions to have higher boiling points and lower freezing points than the pure solvent.

Boiling Point Elevation The change in boiling point is proportional to the molality of

Boiling Point Elevation The change in boiling point is proportional to the molality of the solution: Tb = Kb m where Kb is the molal boiling point elevation constant, a property of the solvent. Tb is added to the normal boiling point of the solvent.

Freezing Point Depression • The change in freezing point can be found similarly: Tf

Freezing Point Depression • The change in freezing point can be found similarly: Tf = Kf m • Here Kf is the molal freezing point depression constant of the solvent. Tf is subtracted from the normal freezing point of the solvent.

Boiling Point Elevation and Freezing Point Depression Note that in both equations, T does

Boiling Point Elevation and Freezing Point Depression Note that in both equations, T does not depend on what the solute is, but only on how many particles are dissolved. Tb = Kb m Tf = Kf m

Colligative Properties of Electrolytes Since these properties depend on the number of particles dissolved,

Colligative Properties of Electrolytes Since these properties depend on the number of particles dissolved, solutions of electrolytes (which dissociate in solution) should show greater changes than those of nonelectrolytes.

Colligative Properties of Electrolytes However, a 1 M solution of Na. Cl does not

Colligative Properties of Electrolytes However, a 1 M solution of Na. Cl does not show twice the change in freezing point that a 1 M solution of methanol does.

van’t Hoff Factor One mole of Na. Cl in water does not really give

van’t Hoff Factor One mole of Na. Cl in water does not really give rise to two moles of ions.

van’t Hoff Factor Some Na+ and Cl− reassociate for a short time, so the

van’t Hoff Factor Some Na+ and Cl− reassociate for a short time, so the true concentration of particles is somewhat less than two times the concentration of Na. Cl.

The van’t Hoff Factor • Reassociation is more likely at higher concentration. • Therefore,

The van’t Hoff Factor • Reassociation is more likely at higher concentration. • Therefore, the number of particles present is concentration dependent.

The van’t Hoff Factor We modify the previous equations by multiplying by the van’t

The van’t Hoff Factor We modify the previous equations by multiplying by the van’t Hoff factor, i Tf = Kf m i

SAMPLE EXERCISE 13. 9 Calculation of Boiling-Point Elevation and Freezing-Point Lowering Automotive antifreeze consists

SAMPLE EXERCISE 13. 9 Calculation of Boiling-Point Elevation and Freezing-Point Lowering Automotive antifreeze consists of ethylene glycol (C 2 H 6 O 2), a nonvolatile nonelectrolyte. Calculate the boiling point and freezing point of a 25. 0 mass % solution of ethylene glycol in water. (Table 13. 4) to calculate Tb and Tf. We add Tb to the boiling point and subtract Tf from the freezing point of the solvent to obtain the boiling point and freezing point of the solution. Solve: The molality of the solution is calculated as follows: We can now use Equations 13. 11 and 13. 12 to calculate the changes in the boiling and freezing points:

SAMPLE EXERCISE 13. 9 continued Hence, the boiling and freezing points of the solution

SAMPLE EXERCISE 13. 9 continued Hence, the boiling and freezing points of the solution are Comment: Notice that the solution is a liquid over a larger temperature range than the pure solvent.

SAMPLE EXERCISE 13. 10 Freezing-Point Depression in Aqueous Solutions List the following aqueous solutions

SAMPLE EXERCISE 13. 10 Freezing-Point Depression in Aqueous Solutions List the following aqueous solutions in order of their expected freezing point: 0. 050 m Ca. Cl 2, 0. 15 m Na. Cl, 0. 10 m HCl, 0. 050 m HC 2 H 3 O 2, 0. 10 m C 12 H 22 O 11. Solve: Ca. Cl 2, Na. Cl, and HCl are strong electrolytes, HC 2 H 3 O 2, is a weak electrolyte, and C 12 H 22 O 11 is a nonelectrolyte. The molality of each solution in total particles is as follows: Because the freezing points depend on the total molality of particles in solution, the expected ordering is 0. 15 m Na. Cl (lowest freezing point), 0. 10 m HCl, 0. 050 m Ca. Cl 2, 0. 10 m C 12 H 22 O 11, and 0. 050 m HC 2 H 3 O 2, (highest freezing point).

SAMPLE EXERCISE 13. 10 continued PRACTICE EXERCISE Which of the following solutes will produce

SAMPLE EXERCISE 13. 10 continued PRACTICE EXERCISE Which of the following solutes will produce the largest increase in boiling point upon addition to 1 kg of water: 1 mol of Co(NO 3)2, 2 mol of KCl, 3 mol of ethylene glycol (C 2 H 6 O 2)? Answer: 2 mol of KCl because it contains the highest concentration of particles, 2 m K+ and 2 m Cl–, giving 4 m in all

Osmosis • Some substances form semipermeable membranes, allowing some smaller particles to pass through,

Osmosis • Some substances form semipermeable membranes, allowing some smaller particles to pass through, but blocking other larger particles. • In biological systems, most semipermeable membranes allow water to pass through, but solutes are not free to do so.

Osmosis In osmosis, there is net movement of solvent from the area of higher

Osmosis In osmosis, there is net movement of solvent from the area of higher solvent concentration (lower solute concentration) to the are of lower solvent concentration (higher solute concentration).

Osmotic Pressure • The pressure required to stop osmosis, known as osmotic pressure, ,

Osmotic Pressure • The pressure required to stop osmosis, known as osmotic pressure, , is =( n ) RT = MRT V where M is the molarity of the solution If the osmotic pressure is the same on both sides of a membrane (i. e. , the concentrations are the same), the solutions are isotonic.

SAMPLE EXERCISE 13. 11 Calculations Involving Osmotic Pressure The average osmotic pressure of blood

SAMPLE EXERCISE 13. 11 Calculations Involving Osmotic Pressure The average osmotic pressure of blood is 7. 7 atm at 25°C. What concentration of glucose (C 6 H 12 O 6) will be isotonic with blood? Solve: Comment: In clinical situations the concentrations of solutions are generally expressed as mass percentages. The mass percentage of a 0. 31 M solution of glucose is 5. 3%. The concentration of Na. Cl that is isotonic with blood is 0. 16 M because Na. Cl ionizes to form two particles, Na+ and Cl– (a 0. 155 M solution of Na. Cl is 0. 310 M in particles). A 0. 16 M solution of Na. Cl is 0. 9 mass % in Na. Cl. This kind of solution is known as a physiological saline solution.

Osmosis in Blood Cells • If the solute concentration outside the cell is greater

Osmosis in Blood Cells • If the solute concentration outside the cell is greater than that inside the cell, the solution is hypertonic. • Water will flow out of the cell, and crenation results.

Osmosis in Cells • If the solute concentration outside the cell is less than

Osmosis in Cells • If the solute concentration outside the cell is less than that inside the cell, the solution is hypotonic. • Water will flow into the cell, and hemolysis results.

Molar Mass from Colligative Properties We can use the effects of a colligative property

Molar Mass from Colligative Properties We can use the effects of a colligative property such as osmotic pressure to determine the molar mass of a compound.

Predict which aqueous solution will have the lowest freezing point. • • • 0.

Predict which aqueous solution will have the lowest freezing point. • • • 0. 25 m C 2 H 5 OH 0. 15 m Ca. Cl 2 0. 20 m Na. Cl 0. 15 m NH 4 NO 3 0. 15 m Na 3 PO 4

Predict which aqueous solution will have the lowest freezing point. • • • 0.

Predict which aqueous solution will have the lowest freezing point. • • • 0. 25 m C 2 H 5 OH 0. 15 m Ca. Cl 2 0. 20 m Na. Cl 0. 15 m NH 4 NO 3 0. 15 m Na 3 PO 4

Arrange the aqueous solutions according to increasing boiling point. • • • Al. Cl

Arrange the aqueous solutions according to increasing boiling point. • • • Al. Cl 3 < KNO 3 < Na 2 SO 4 < Al. Cl 3 < KNO 3 Na 2 SO 4 < KNO 3 < Al. Cl 3 < Na 2 SO 4 KNO 3 < Na 2 SO 4 < Al. Cl 3 0. 10 m Na 2 SO 4 0. 15 m Al. Cl 3 0. 20 m KNO 3

Arrange the aqueous solutions according to increasing boiling point. • • • Al. Cl

Arrange the aqueous solutions according to increasing boiling point. • • • Al. Cl 3 < KNO 3 < Na 2 SO 4 < Al. Cl 3 < KNO 3 Na 2 SO 4 < KNO 3 < Al. Cl 3 < Na 2 SO 4 KNO 3 < Na 2 SO 4 < Al. Cl 3 0. 10 m Na 2 SO 4 0. 15 m Al. Cl 3 0. 20 m KNO 3