SDT DT Series Product Introduction V 3 0

SDT & DT Series Product Introduction V 3. 0

Product Features Maximum Efficiency up to 98. 3% 45°C full-load output (environmental) European Efficiency up to 98% IP 65 dust-proof and waterproof MPPT Efficiency up to 99. 9% Multiple monitoring and communication

1. 4 Technical Parameters

Technical Parameters Ø Good. We SDT 4~15 k. W Technical Parameters

Technical Parameters

Technical Parameters

Technical Parameters

Technical Parameters

Technical Parameters Ø Good. We DT 15~25 k. W Technical Parameters

Technical Parameters

Technical Parameters

Technical Parameters

Technical Parameters

2. 1 Hardware Installation Guide

Hardware Installation Guide Open Box Communication Terminals Connection Accessories Check Wall-mounted Bracket Installation AC Terminals Connection DC Terminals Connection SDT Installation

Hardware Installation Guide l You may need below tools when you install the EM Wire stripping pliers Drilling tool Straight screwdriver Line pressing tools Cross screwdriver Knife

Hardware Installation Guide Step 1：Open box

Hardware Installation Guide Step 2: Accessories Check 1 AC Termin al x 6 6 3 2 3 6 PIN Termina l 4 2 PIN Termina l 4 8 2 Pan head screw × 5 10 9 Expansion Bolts × 6 5 Negativ e DC Plug Positive DC Plug Wallmounted Bracket x 1 7 1 Wi. Fi Module × 1 AC cover × 1

Hardware Installation Guide Step 3: Wall-mounted Bracket Installation 1. Holes location 2. Drill holes 3. Six holes 4. Expansion bolts fixed 5. Wall-mounted Bracket installation 6. Done

Hardware Installation Guide Step 4: SDT Installation 1 Right side 2 Left side 3 Down side Overview

Hardware Installation Guide Step 5: DC Terminals Connection 1 10 Note : 2 9 3 4 8 Before connecting PV string, make sure DC switch is turned off. 5 7 6

Hardware Installation Guide Step 6: AC Terminals Connection 1 10 2 9 3 4 5 8 7 6

Hardware Installation Guide Step 6: AC Terminals Connection Ø The SDT&DT inverter’s on-grid cables L 1 , L 2 , L 3 and N need to go through a 40 A outside breaker which is showed as right picture to connect to the grid;

Hardware Installation Guide Step 7: Communication Terminals Connection Ø If you use Wi. Fi/GPRS module for communication , please refer to below steps for connection.

Hardware Installation Guide Step 7: Communication Terminals Connection Ø If you use RS 485 for communication , please refer to below steps for connection. Inverter side: 1 2 3 4 5 Ez. Logger Pro side: 1 If you use 6 PIN connector , the way to make the connector is the same. 4 5