PST Heaters Proposed Segmentation Forward 2289 mm 6

PST Heaters – Proposed Segmentation Forward = 2289 mm. 6 hoops. 10 heaters Barrel = 1606 mm. 4 hoops. 7 heaters

Services Document 2_17 • The services document assumes the following Barrel 12 supply lines Each forward 24 supply lines • Each supply line means 2 wires, one in and one out. • Total wires are then 2 x(12+2 x 24)=120 • Total number of temperature sensors(each has two wires) is 120 in this document, so this is 240 wires. 2

Proposed Ganging of Heaters • • Top heaters: gang two => two wires per 2 segments Right heaters: gang two => two wires per 2 segments Left heaters: gang two => two wires per 2 segments Bottom heaters: gang two but take out another wire so that could be hooked up in case of failure. • So for 2 segments there are 9 wires and 4 power supplies, one wire being normally disconnected. • Connection to SCT heaters: one heater circuit on each connection => 8 total wires. 3

Proposed Wires and Circuits 7 barrel segments. 2 x 10 end segments PST heater wires and power supplies from barrel region 3 x 9 + one special segment of 8 wires = 35 wires 3 x 4 + 4 power supplies = 16 power supplies PST heater wires and power supplies from each end region 5 x 9 = 45 wires 5 x 4 = 20 power supplies SCT mount heaters 4 x 2 = 8 wires 4 power supplies Temperature sensor per panel=> 108 sensors + 4 for mount heaters. Total temperature sensors = 112 => 224 wires 4

Proposed Power • • We assume each panel is 20 ohms(to be verified on prototype) Desire about 20 W per panel Two panels in series are 40 ohms. A power supply voltage of 48 V gives about 1 A with a bit of margin. 5

Summary of Request Service doc has 120 heater wires and 240 temperature sensor wires. This has a few more heater wires and fewer temperature sensor wires. . 6