Project Title Synopsis Objectives Investigation and Simulation on

Project Title: Synopsis: Objectives: Investigation and Simulation on the transmission, emersion and dispersion of dust particles from the point of generation. Dust particles are often an unwanted by-product of machining materials. Managing dust particles are challenging due to its size. Despite isolating the work area, dust particles would always escape. Therefore, simulating and learning the flow of dust particles would make it easier to control it. 1. To investigate the generation of dust particles as a by-product in manufacturing. 2. To simulate the transmission, emersion and dispersion of dust particles from the generation site 3. To propose solutions in containing the dust particles from becoming a serious hazard in the industry Equipment required: Software required: CFD Software Supervisor (Department): DR. MOHD SAYUTI BIN AB KARIM Program: Master of ______ Engineering Duration: Maximum 2 consecutive semesters

Project Title: Synopsis: Objectives: Investigation on the occupational injury and diseases that occur despite following OSHA Standards. Occupational injury and diseases are constantly showing up in our country despite the strict occupational health and safety standards. This clearly shows that there is a flaw in the system. Therefore, finding out the cause would help in solving this problem. 1. To investigate the recent occupational injury and diseases cases and their causes 2. To evaluate the relationship between the causes and the OSHA Standards and figuring out the flaw 3. To find remedies to solve the flaw and decrease the number of cases. Equipment required: Software required: Supervisor (Department): DR. MOHD SAYUTI BIN AB KARIM Program: Master of ______ Engineering Duration: Maximum 2 consecutive semesters

Project Title: Synopsis: Investigation on the trend of occupational injuries and diseases based on the type of industry, the economic growth and safety regulations. The occupational injury and diseases data have not been properly studied and related to the environmental factors to find out its relations. If the relationship between these variables has been found, future prediction and problem solving would be easy. Therefore, the current occupational injury and diseases has to be studied. Objectives: 1. To determine the recent occupational injury and diseases data based on their respective industries 2. To investigate the relationship between the data observed with the environmental factors involved such as the economic growth and the safety regulations 3. To predict the future data and the find the solution by using the relationship found. Equipment required: Software required: Supervisor (Department): DR. MOHD SAYUTI BIN AB KARIM Program: Master of ______ Engineering Duration: Maximum 2 consecutive semesters

Project Title: Classification of high voltage cable joint defects using support vector machine and noise reduction on partial discharge signals Synopsis: In this work, classification of high voltage cable joint defect types using support vector machine and noise reduction techniques on partial discharge signals will be performed. Four cross-linked polyethylene (XLPE) cable joints with artificially created defects will be prepared based on the defects commonly encountered on site. Different noise reduction techniques will be applied to denoise the PD signals. The denoised signals will be used as a feature for classification of defects in cable joints using support vector machine. The classification results will be compared between the proposed method and the existing works to evaluate the performance of the applied techniques. Objectives: 1. To perform measurement of partial discharge (PD) on artificially-prepared cable joint defects 2. To apply support vector machine and various noise reduction methods on PD signals for classification of XLPE cable joint defects 3. To compare the classification results between the proposed method and the existing works Equipment required: Partial discharge measurement setup, high voltage generation kit, cable joint Software required: MATLAB, partial discharge analysis software E L P M A X E Supervisor (Department): Assoc. Prof. Ir. Dr. Hazlee Azil Illias (Electrical) Program: Master of Power System Engineering / Master of Engineering (Power System) Duration: Maximum 2 consecutive semesters