Process Steps Cabinet for PAPR Storage Step 1

Process Steps Cabinet for PAPR Storage Step 1: Take PAPR out of supply room Step 2: Use PAPR Step 3: After use, clean PAPR with Sanicloth (see next slide) Step 4: Return with charged battery to cabinet. PAPRs are required for patients on Airborne Precautions if you have not passed or have not been fit-tested for N 95 masks. PAPRs or N 95 masks are required to enter all airborne isolation rooms Maxair parts are in Oracle and are the responsibility of the owning department where stored. What's New in The Center for Care and Discovery?

Max Air PAPR Instructions Before first use and for subsequent uses While holding ratchet knob with 1 hand, pull down lens cuff with other and don helmet. Tighten ratchet by turning knob to right for proper fit. Inspect fit in front of ears, above eyebrows & around cheeks to ensure a good seal. Airflow will start once helmet is plugged into battery. Watch LED lights to signal equipment maintenance. Remove PAPR System. Dispose of Lens Cuff Note: this is the only disposable part of the PAPR. Yellow indicates low air flow, replace filter. Green indicates good battery level. Red indicates NOT MRI SAFE low battery. At the end of use: Dispose of the lens cuff and comfort strips. Wipe non-disposable parts with purple LEDall lights are located inside top Saniwipes (or orange top Saniwipes if appropriate for patient status). Charge the battery, replace frontwith of helmet. disposable lens cuff and comfort strips, place in storage box and lock break away tie. Change HEPA When wearing filter when yellow light is illuminated or if grossly contaminated. helmet, just look up.