HANDLE JOG MODE The HAAS Control Series SLIDE

HANDLE JOG MODE The HAAS Control Series

SLIDE LEGEND PRESS ACTIONS KEYS THREE TIMES TO GET TO THIS PAGE INSTRUCTIONS (Continued on next slide) INFORMATION Note: OTHER INFORMATION To advance through the presentation click on your left mouse button or press <ENTER>. To exit press <ESC>.

HANDLE JOG MODE This module is intended to provide you with a familiarization of the Handle Jog Mode on the Haas Control

Here is where you find the Handle Jog Buttons

Handle Jog Buttons HANDLE JOG: . 0001. 1: . 001 1. : . 01 10. : . 1 100. : Pressing the Handle Jog button on the control will display the Position screen. Used to manually move the machine axes by using the Jog Keys or the Hand Wheel.

Handle Jog Button: POSITION Handle Jog Button: Press <HANDLE JOG> This will bring up the Position screen that will allow you to move the machine axes by using the Jog keys or the Hand wheel. If you select the DISTTO-GO display, it will zero all axes when you select the Handle Jog Mode of operation. (EDIT) O 91002 F 1 KEY TURNS MENU ON/OFF (OPERATOR) X 0. 0000 in (WORK G 54) X 12. 1705 in Y 0. 0000 in Y 8. 0000 in Z 0. 0000 in X Y Z (MACHINE) 0. 0000 in JOGGING AXIS @ FEED 1. (DIST TO GO) X 12. 1705 in Y 8. 0000 in Z 0. 0000 in

Resolution/Feed Rate Buttons: POSITION These four keys select Hand wheel Resolution and the Jog Feed Rate. The number on the top indicates Hand wheel Resolution. (Amount of movement per click) The number on the bottom indicates the Jog Feed Rate in inches per minute when using the Jog keys. An axis must be selected for movement to occur. (EDIT) O 91002 F 1 KEY TURNS MENU ON/OFF (OPERATOR) X 0. 0000 in (WORK G 54) X 12. 1705 in Y 0. 0000 in Y 8. 0000 in Z 0. 0000 in X Y Z (MACHINE) 0. 0000 in JOGGING AXIS @ FEED 1. (DIST TO GO) X 12. 1705 in Y 8. 0000 in Z 0. 0000 in

Handle Jog: While jogging the machine, the FEED RATE OVERRIDE buttons will adjust, in increments of +/-10%, the feed rate that is programmed into the control. The Hand Wheel can be used to adjust, in increments of 1%, the feed rate that is programmed into the control.

Handle Jog: With the spindle running, the SPINDLE OVERRIDE buttons will adjust, in increments of +/-10%, the speed that is programmed into the control. The Hand Wheel can be used to adjust, in increments of 1%, the speed that is programmed into the control.

Handle Jog: The JOG LOCK key will cause the axes you are jogging to continue jogging. Press <JOG LOCK> then press the axis key you want to jog. While in motion, you can switch axis by pressing the axis you want to move. Motion will stop by pressing <JOG LOCK>, <FEED HOLD> or <RESET>.

Prepared by Haas Automation Training Department Oxnard, CA 93030