Document for Technical and Sales Training KXNS 1000

Document for Technical and Sales Training KX-NS 1000 Basic Specification August 22, 2014 Panasonic System Networks PBX SE team This document explains basic specification of KX-NS 1000 version 4. 1. It is recommended to know basic specification of KX-NS small PBX before reading this document. Specifications are subject to change without notice.

1. Introduction KX-NS 1000 is bigger capacity model of KX-NS PBX series. KX-NS 1000 supports 1, 000 extensions. 1, 000 IP phone or 1, 000 Digital PT or 1, 000 SLT or 1, 000 mixture KX-NS 1000 supports lots of built-in solution. Voice Mail, Unified Message, Recording, Call center, Unified Communication, Mobility, Conference, One-look networking and so on KX-NS 1000 KX-NS 8188 E 1 adapter KX-NS 8290 PRI adapter Built-in Solution KX-NS 1000 Slave Master KX-NS 0130 IP Network KX-TDE 620 etc 1, 000 Extension KX-DT w/ DSS Console SLT KX-NT KX-UT Other SIP KX-DT SIP Phone Softphone Max. 16 KX-NS 1000 KX-T 7 xxx SLT 100 % Feature transparency like TDE 600 and TDE 620 2

2. Feature Difference KX-NS small PBX and KX-NS 1000 have same feature basically like KXNCP and KX-TDE. Feature difference is as follows. Feature KX-NS small PBX KX-NS 1000 Yes (as slave) Yes Trunk Adapter : KX-NS 8188/8290 See “ 1. NSx 00 Basic Spec 2014 -xxxx. pptx. ” Yes RS 232 port No but SMDR through LAN Yes LAN port 10/100 Base TX 10/1000 WAN port No Yes MNT port No but USB port with adapter Yes Fax to e-mail No Yes Sensor to e-mail Yes (Version 4. 1) Simple VM Yes (*) No Modem : KX-TDA 0196 Yes (*) No PT Program Yes (*) No 40, 000 calls SMDR by SD Yes (*) No One-look network (*) These features are not available when KX-NS small PBX is connected with KX-NS 1000 by one-look network. 3

3. Table of Contents Chapter Contents 1 Basic configuration 2 Stacking card / One-look networking 3 Trunk adapter (E 1/PRI) 4 WAN (Built-in Router) 5 Activation key 6 Capacity (Review & Conditions) 4

Chapter 1 Basic Configuration 5

13. KX-NS 1000 Main Unit Front View A D C B G H E J I Back View N M O P Q F R A 3 Indicator for (1) System (2) Battery (3) Master / Slave B Default Switch C USB Port D LAN port for maintenance PC (*) E LAN Port for customer network F WAN Port M Power Switch N Earth Terminal O AC Inlet P Clip Hole for AC cable Q MPR ID R RS-232 C Port G MOH Port H Pager Port I Doorphone Slot J Free Slot (*) D is independent from E. D is useful when PC for maintenance is not allowed to connect to customer’s network. D and E for TDE/NCP were for same network. 6

14. Optional Cards on Mother Board Two DSP can be installed. Hot swap is not available. 7

15. Optional Cards on Front 2 analogue trunk ports with Caller ID (FSK/FSK with Call Waiting Caller ID /DTMF). One port is a power failure transfer (PFT) port. 2 extension ports with Caller ID (FSK) for SLTs. Hot swap is not available. 8

Chapter 2 Stacking Card One-look Network 9

21. Stacking Card When customer needs lots of analog SLT, digital PT, analog CO, PRI and so on, KX-NS 1000 with stacking card KX-NS 0130 is useful. - KX-TDA 100 -200 -620, KX-TDE or KX-NCP works as slave unit. - 2 slave units are supported with one KX-NS 1000 by one KX-NS 0130. - KX-NS 0131/0132 is installed to slave unit instead of MPR or BUS card. - KX-TDA(E)620 cannot be connected with KX-TDA(E)600 by BUS card. KX-NS 1000 Built-in Solution KX-NS 0130 DSP KX-DT w/ DSS Console Stacking card for NS 1000 KX-NS 0131 Stacking card for NCP KX-NS 0132 Stacking card for TDA/TDE IP Network KX-TDE 620 etc 640 Extension KX-NS 0130 SLT KX-NT KX-UT Other SIP Phone Softphone 100 % Feature transparency like TDE 600 and TDE 620 10

22. One-look Networking A maximum of 12 KX-TDA/TDE/NCP and 16 KX-NS 1000 can be connected for the entire One-look Network for 1, 000 extensions. One-look networking is similar to TDE 600 -TDE 620 connection. KX-NS 1000 master works like KX-TDE 600. Other units work like KX-TDE 620. All programming is available through KX-NS 1000 master like KX-TDE 600. Activation key : KX-NSN 001 is required for each KX-NS PBX. Max. 16 Built-in KX-NS 1000 Solution KX-NS 1000 Slave Master KX-NS 0130 DSP KX-DT w/ DSS Console KX-NS 0130 IP Network KX-TDE 620 etc Max. 12 KX-TDA/TDE/NCP 1, 000 Extension DSP SLT KX-NT KX-UT Other SIP KX-DT SIP Phone Softphone KX-T 7 xxx SLT 100 % Feature transparency like TDE 600 and TDE 620 Maximum of KX-TDA/TDE/NCP was 8 for KX-NS 1000 version 4. 0 or before. 11

23. One-look Networking with KX-NS small PBX A maximum of 15 KX-NS small PBX also can be connected for the entire One-look Network as slave PBX. Master PBX should be KX-NS 1000. Activation key : KX-NSN 001 is required for each PBX. Hardware : DSP such as KX-NS 5110 is required because Vo. IP is used for connection. (A) Max. 12 KX-TDA/TDE/NCP (B) Max. 24 KX-NS 320 KX-NS 520 KX-NS 720 KX-NS 1000 DSP KX-NS 0130 KX-NS small PBX DSP IP Network (C) KX-NS 1000 master + 15 KX-NS 1000 or KX-NS small PBX Max. 1, 000 Extension (A)+(B) Total DSP TDA/TDE/NCP 0 1 2 3 4 5 6 7 8 9 10 11 12 NSx 20 24 22 20 18 16 14 12 10 8 6 4 2 0 KX-NS 300 : KX-NSF 990 AK and SD card such as KX-NS 3134 are also required. KX-NS 700 : KX-NSF 991 AK is also required. KX-NS small PBX cannot be master (including back-up master) because not enough CPU. 12

24. Upgrade from QSIG When customer is using KX-TDA/TDE/NCP with Q-SIG, KX-NS 1000 with one-look networking is useful for more features such as paging. IP Network KX-TDE 620 Stacking KX-TDE 600 KX-NCP IP Network KX-TDE 600 Stacking KX-TDE 620 Stacking KX-NCP Stacking Max. 8 PBXs QSIG KX-DT KX-DT Paging 100 % Feature transparency 13

Chapter 4 WAN (Built-in Router) 14

41. WAN (Built-in Router) is supported from KX-NS 1000 version 3. Hardware for WAN is available since version 1 mass production. Activation key : KX-NSN 101 is required. One internet line can be used for both PC and Vo. IP. LAN IP Network WAN Router Port Fwd LAN for Maintenance LAN (Customer’s network) 223. 0. 0. 1 (Default) 192. 168. 0. 101 (Default) When customer wants to add one more internet for Vo. IP (Extension or Trunk), Add one more router. IP Network Or use built-in router. Port Fwd is not required. WAN Router Fwd Router LAN IP Network WAN 15

42. Built-in VPN WAN / Built-in Router can support VPN (IP-SEC) feature also. VPN is required if one-kook network is configured using built-in router. Activation key : KX-NSN 216 is required. (KX-NSN 101 is also required. ) One KX-NSN 216 supports 16 VPN connection. Max. two AKs can be supported for 32 VPN connection. IP phone also can be connected using VPN for secured communication instead of MRG feature. Easy Installation even for VPN by Panasonic technology “VPSS”. IP Network VPN Router External VPN Router 16

Chapter 5 Activation Key 17

51. Activation key only for KX-NS 1000 Following activation key is only for KX-NS 1000. 18

52. Activation Key for Expansion Following activation key was added from KX-NS 1000 version 3. These AK are required for each master and slave PBX. Model Name Feature Maximum KX-NSX 910 Expansion AK from NSM 005 1 AK IP phone Capacity is increased to 100 ports KX-NSX 930 Expansion AK from NSM 010 1 AK IP phone Capacity is increased to 300 ports KX-NSX 999 Expansion AK from NSM 030 1 AK IP phone Capacity is increased to 640 ports 30 50 Description 100 300 640 IP phone Pre-installed NSX 930 NSX 910 NSM 005 NSX 930 NSM 010 NSM 030 NSM 099 NSX 999 60 days free trial is NOT available. 19

53. Pre-installed Activation Key Following features are available without buying activation key and without expiration. IP Extension for KX-UT and KX-NT hardware phone : 8 ch - Not for KX-NT 700 and KX-NT based software phone - Not for 3 rd party SIP phone => Easy to sell Panasonic KX-UT and KX-NT UM (Built-in KX-TVM) : 2 ch CA Basic (Built-in server / External server) : All users 20

Chapter 6 Capacity (Review and Conditions) 21

61. Capacity - Summary Capacity is as follows. Line NS 1000 x 1 NS 1000 x 2 NS 1000 x 3 to 16 256 x 2 600 Legacy 256 x 2 600 IP incl E 1/PRI adapter 256 SIP incl PRI Public mode 256 H. 323 incl PRI QSIG mode 48 96 640 1000 480 SLT (*1) 512 DPT (*2) 1000 640 1000 Trunk Extension Digital PT / Analog PT / SLT IP (*1) 24 SLT x 10 by TDE 620 x 2 for example (*2) 256 DPT including DXDP by TDE 620 x 2 for example Capacity is occupied when hardware card and virtual IP card are installed, even if phone is not connected actually. For example, one DLC 16 occupies 32 -ch including Digital XDP. 22

63. Capacity - KX-NT capacity for one unit of KX-NS 1000 can be increased. Type 1 or Type 2 can be selected after default clear. Type 1 (Default) Stand Alone One-look 640 1000 IP-PT (KX-NT series) 256 1000 SIP 640 1000 SIP Phone 640 1000 KX-UT series 640 1000 Stand Alone One-look 640 1000 IP-PT (KX-NT series) 640 1000 SIP 256 1000 SIP Phone 256 1000 KX-UT series 256 1000 IP 　 　 Type 2 IP 　 　 Type 3 is also available to increase H. 323 ch. : 128 ch for NS 1000 2 or more unit But capacity of IP extension reduces. See Installation manual for details. 23

64. Capacity - Conditions One VM channel reduces 10 -port extension capacity of master PBX because CPU of master PBX needs more power for VM. - Default 2 -ch does not reduce this. - Extension capacity of slave PBX does not reduce, even if slave PBX has VM because CPU of slave PBX is not so busy. Total 1000 extensions Master PBX VM (ch) VM Extension Slave PBX VM (ch) VM Extension Default 2 640 2+2 620 2+2 640 2+4 600 2+4 640 : : 2 + 22 420 2 + 22 640 24

66. DSP Configuration Tool Capacity of DSP can be confirmed using programming tool without PBX before installtion. (Off-line mode) 25

67. DSP Booking DSP can be booked for more important purpose by programming. <Above example> 3 ch OGM(DISA) can be used always. 4 or more ch OGM(DISA) can be used from “Free resources”. 26

68. DSP Report DSP report is supported. 27

Thank you ! 28

Revision Date No. Aug 22 All Change First release 29