Automotive Training Equipment Training stand with CAN BUS

Automotive Training Equipment Training stand with CAN – BUS mains data transmission system. YESA-10007 LT Feature & Specification Fully functional CAN – BUS network system is installed on a mobile frame construction. Stand is equipped with a functional CAN GATEWAY 2. 0 system or analog Technical specifications and functions The training board is equipped with a CAN gateway 2. 0 network system that includes: – Central control block CAN Gateway 2, 0 or analog; – Dashboard – Engine conrol EVB; – Steering column electronic locking mechanism; - Ignition lock, lock and immobilizer; - SRS system control unit; • Vehicle door central locking control unit; - windows lifting motors - windows lifting switches -All the components are connected to the internal network. The Network is shown as a diagram for better understanding; The modules communications can be connected or disconnected by banana plug jumpers. There can be disconnected Low and High speed CAN lines on the stand; CAN getaway diagram with built in banana plug jumpers for measurements and simulation of system malfunctions; - Removable joints for measuring contacts should allow simulation of at least 10 system errors; -the window lifting motors are active and controlled by a switches and doors control EVB modules through CAN gateway network of the car; . *Note. Image, specification and model No. of equipment can be changed by manufacturing process without special reporting. YES 01, Youngil Education System 1 www. yes 01. co. kr/en Tel : 82 -2 -2024 -0077

Automotive Training Equipment Training stand with CAN – BUS mains data transmission system YESA-10007 LT Feature & Specification Diagnostic and measurement Oscilloscope/multimeter -Diagnosis through EOBD (J 1962) 16 – pin diagnostic connector; -Diagnose all presented control units in the CAN bus network by using an automatic search • Diagnostics of each control unit by implementing the following tests: Reading the control unit identification; Reading/erasing fault codes Monitoring of system performance parameters; Activating the actuators Control unit EVB encoding/configuration Other - The stand has a closed structure – internal wiring is not visible -In set comes CAN Network analyzer - The kit include the model board network power supply block from the AC supply: 220/12 V; *Note. Image, specification and model No. of equipment can be changed by manufacturing process without special reporting. YES 01, Youngil Education System 2 www. yes 01. co. kr/en Tel : 82 -2 -2024 -0077