Automotive Training Equipment Brake Antilock AntiSlip ABS ASR
Automotive Training Equipment Brake Anti-lock / Anti-Slip ABS / ASR training stand YESA-10001 LT Feature & Specification Description: The training stand must be fitted with a functional electronic ABS anti-lock system ABS / ASR, the stand must be mounted on a mobile aluminum frame structure. On the stand must be installed original components of car Technical specifications and functions: - The stand is equipped with a functional BOSCH 5. 3 ABS braking system and anti-slip system; - The stand provide posibility of brake force distribution monitoring - installed pressure gauges control manometers, as for common line and also for each brake cylinder contour; - The training stand is equipped with original hydraulic brake system, the brake pads of the brake drums are used instead of the brake discs, to show better, when the pressure rises up and the braking moment starts; - The diagrams and scheme of the stand should reflect the operating modes of the hydraulic system; • The stand should include a basic electrical circuit with measuring contacts built into the system element; • Measuring contacts for removable connections should be able to simulate system errors. Diagnostic and measurement Oscilloscope/multimeter -System’s parameters are measured by connecting to the banana connector; - Ability to measure electrical signal parameters of each system component; *Note. Image, specification and model No. of equipment can be changed by manufacturing process without special reporting. YES 01, Youngil Education System 1 www. yes 01. co. kr/en Tel : 82 -2 -2024 -0077
Automotive Training Equipment Brake Anti-lock / Anti-Slip ABS / ASR training stand YESA-10001 LT Feature & Specification Control unit (EVB) diagnostics and minimal functions -through EOBD 16 – pin diagnostic connector; -Electronic control unit identification; - Fault codes reading / erasing; - Displaying the operating system parameters; - Activating the actuators Other parameters and requirements • The stand has a closed structure – internal wiring is not visible • The stand must also include an on-board power supply block from: 220 to 12 V; *Note. Image, specification and model No. of equipment can be changed by manufacturing process without special reporting. YES 01, Youngil Education System 2 www. yes 01. co. kr/en Tel : 82 -2 -2024 -0077
- Slides: 2