1 Drive shaft Inlet cone BMW rear axle
• 하이드로포밍의 적용(1) Drive shaft Inlet cone BMW rear axle
Tube vs. Sheet Hydroforming
Production line for tube hydroforming
Tube bending(1)
Tube bending(2)
Tube bending(3)
금형 구조(1) Schematic view of a die layout
금형 구조(2) Die systems for prototyping and production
금형 구조(3) Hole punching, notching and bending during hydroforming
하이드로포밍 범위(1) Internal pressure as a function of the inside radius
하이드로포밍 범위(2) Hydroforming parts for the fitting industry
하이드로포밍 범위(3) Present state of the art in hydroforming using tubes as blanks
하이드로포밍 범위(4) Achievable branched tube heights The achievable height decreases with an increasing degree of difficulty
Hydroformed Products
Exhaust gas system(1) • 2, 01 -16 V-4 -cylinde • Heat resistant stainless steel
Exhaust gas system(2) • M 3 6 -cylinder • Heat resistant stainless steel
VW-Hydroformed subframe for 4 WD drive rear axle
Light truck side rail
Engine cradle • Modified low carbon steel St 3 • Pre tube 2, 600*65*2 mm for Opel Astra and Zafira
Production lines installed since 1997
Hydroformed R&D-front-end
하이드로포밍 설비(1) Frame-type hydroformin g press
하이드로포밍 설비(2) Compacting presses/IHV-presses
하이드로포밍 설비(3) IHV-plant for large-scale series production
하이드로포밍 설비(4) IHV-press/IHV-control/Robots
하이드로포밍 설비(5) Press plant 2*50, 000 k. N
하이드로포밍 설비(6) Press plant for the production of Cu T-fittings
- Slides: 32